RTS DV-3400 Technical Information PDF herunterladen (Seite 303)

100

101

Port Trunking

CLI: Viewing and Configuring Port Trunk Groups

7. When you are finished assigning ports to the trunk group, press [Enter],

then

[S] (for Save) and return to the Main Menu. (It is not necessary to

reboot the switch.)

During the Save process, traffic on the ports configured for trunking will

be delayed for several seconds. If the Spanning Tree Protocol is enabled,

the delay may be up to 30 seconds.

8. Connect the trunked ports on the switch to the corresponding ports on

the opposite device. If you previously disabled any of the trunked ports

on the switch, enable them now. (See “Viewing Port Status and Configur-

ing Port Parameters” on page 10-2.)

Check the Event Log (“Using the Event Log To Identify Problem Sources” on

page C-27) to verify that the trunked ports are operating properly.

CLI: Viewing and Configuring Port Trunk

Groups

Trunk Status and Configuration Commands

show trunks below

show lacp page 13-13

trunk page 13-15

interface < port-list > lacp page 13-15

Using the CLI To View Port Trunks

You can list the trunk type and group for all ports on the switch or for selected

ports. You can also list LACP-only status information for LACP-configured

ports.

13-11

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 579 580

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS DV-3400 Technical Information Seite 303

Kommentare zu diesen Handbüchern