RTS DV-3400 Technical Information PDF herunterladen (Seite 214)

Port Status and Basic Configuration

Viewing Port Status and Configuring Port Parameters

Status or

Parameter

Description

— Continued From Previous Page —

100/1000Base-T Ports:

• auto-mdix (default): Senses speed and negotiates with the port at the other end of the link for port

operation (MDI-X or MDI).

To see what the switch negotiates for the Auto setting, use the CLI show interfaces brief command

or the “3. Port Status” option under “1. Status and Counters” in the menu interface.

• mdi: Sets the port to connect with a PC using a crossover cable (Manual mode—applies only to copper

port switches using twisted-pair copper Ethernet cables)

• mdix: Sets the port to connect with a PC using a straight-through cable (Manual mode—applies only

to copper port switches using twisted-pair copper Ethernet cables)

• Auto-100: Uses 100 Mbps and negotiates with the port at the other end of the link for other port

operation features.

• Auto-1000: Uses 1000 Mbps and negotiates with the port at the other end of the link for other port

operation features.

• 100Hdx: Uses 100 Mbps, half-duplex.

• 100Fdx: Uses 100 Mbps, Full-Duplex

Notes:

• Changing the port speed on a transceiver port requires a reboot of the switch.

• Ensure that the device attached to the port is configured for the same setting that you select here.

Also, if “Auto” is used, the device to which the port connects must also be configured to “Auto” and

operate in compliance with the IEEE 802.3ab “Auto Negotiation” standard for 1000Base-T networks.

10/100/1000Base-T Ports:

• auto-mdix (default): Senses speed and negotiates with the port at the other end of the link for port

operation (MDI-X or MDI).

To see what the switch negotiates for the Auto setting, use the CLI show interfaces brief command

or the “3. Port Status” option under “1. Status and Counters” in the menu interface.

• mdi: Sets the port to connect with a PC using a crossover cable (Manual mode—applies only to copper

port switches using twisted-pair copper Ethernet cables)

• mdix: Sets the port to connect with a PC using a straight-through cable (Manual mode—applies only

to copper port switches using twisted-pair copper Ethernet cables)

• Auto-10: Allows the port to negotiate between half-duplex (HDx) and full-duplex (FDx) while keeping

speed at 10 Mbps. Also negotiates flow control (enabled or disabled). ProCurve recommends Auto-

10 for links between 10/100 auto-sensing ports connected with Cat 3 cabling. (Cat 5 cabling is required

for 100 Mbps links.).

• 10HDx:10 Mbps, Half-Duplex

• 10FDx: 10 Mbps, Full-Duplex

• Auto-100: Uses 100 Mbps and negotiates with the port at the other end of the link for other port

operation features.

•

Auto-1000: Uses 1000 Mbps and negotiates with the port at the other end of the link for other port

operation features.

• 100Hdx: Uses 100 Mbps, half-duplex.

• 100Fdx: Uses 100 Mbps, Full-Duplex

— Continued on Next Page —

10-4

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 579 580

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS DV-3400 Technical Information Seite 214

Kommentare zu diesen Handbüchern