RTS DV-3400 Technical Information PDF herunterladen (Seite 279)

100

101

Access Controller xl Module for the Series 5300xl Switches

Configuring the Access Controller xl Module

Configuring Client VLANs

You may configure a client VLAN with a specific VID, containing just the

downlink port as a tagged member. Later, you can add an untagged 5300xl

port as a downlink client port to carry client traffic.

Use the following command to configure a client VLAN:

ProCurve (Config)# access-controller <slot-id> client-ports vlan <vlan-list>

where <slot-id> is the slot letter where the module is installed.

<vlan-list> is the VID for the desired client VLAN.

Configuring Uplink Network Ports

Uplink network ports are any switch ports that are members of the uplink

VLAN, that is, the VLAN where the ACM’s internal uplink port is an untagged

member. By default, the uplink port (<slot-id>UP) is an untagged member of

the DEFAULT-VLAN on the 5300xl switch. In this default configuration, all

members of the DEFAULT-VLAN are uplink network ports.

Configuring the Uplink VLAN

To change the uplink VLAN, make the internal uplink port an untagged member

of a new VLAN. Be sure that the new VLAN allows communication with the

740wl/760wl, or communications is lost.

ProCurve (Config)# vlan 25 untagged <slot-id>up

where slot-id is the 5300xl switch slot where the ACM module is installed.

This command configures a new uplink VLAN, VID 25, for the ACM module

installed in slot n.

12-19

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 579 580

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS DV-3400 Technical Information Seite 279

Kommentare zu diesen Handbüchern