RTS DV-3400 Technical Information PDF herunterladen (Seite 274)

100

101

Access Controller xl Module for the Series 5300xl Switches

General Operating Rules

■ Uplink and downlink ports cannot be members of the same VLAN.

■ Switch 5300xl features used to manage ports that are connected to

bridges don’t apply, as the ACM is not a bridge.

■ A client VLAN containing the downlink port, <slot-id>DP, is automat-

ically created when the ACM is installed in a 5300xl switch. The VID

for this VLAN is the vlan-base (default: 2000). You cannot remove a

client VLAN if it is the only remaining VLAN with the downlink port

as a member.

■ Client VLANs may not be configured as the Management or Primary

VLAN on the 5300xl switch.

■ Multiple subnets on a downlink client port are not supported.

■ Shut down the ACM

• before resetting or reloading the 5300xl chassis

• before turning off the 5300xl chassis.

• before removing the module from the 5300xl chassis.

See the shutdown command in 12-“ACM Configuration Commands Sum-

mary and Syntax” on page 12-20.

Configuring the ACM on the Network

By default, the ACM uses DHCP to get an IP address. The uplink port of the

ACM must be an untagged member of a VLAN that can communicate with the

740wl/760wl. If that communication is routed, the Default gateway: needs to be

present in the IP address configuration. When the IP address is assigned

manually be sure to configure the Default gateway: if it is needed. (See “Using

the ACM’s Extended CLI” on page 12-27.)

Use the following commands to configure an IP address manually.

12-14

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 579 580

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS DV-3400 Technical Information Seite 274

Kommentare zu diesen Handbüchern