RTS Cstrunk Spezifikationen PDF herunterladen (Seite 85)

Configure the RVON-8 using AZedit to contact the RVON-1

To configure the RVON-1 card, do the following in AZedit:

1. From the Status menu, select I/O Cards.

The I/O Card Status screen appears showing the types of installed.

2. Right click on an RVON-8 card, and then select RVON-8 Configuration.

The RVON-8 Configuration screen appears.

NOTE: The RVON-8 you use should be already configured. If it is not configured, refer to your RVON-8

Card User Manual.

NOTE: Remember, the RVON-1 has only one channel that can be configured.

3. In the RVON-8 Channel drop down list, select the channel to be used to communicate to the RVON-1 card across

network.

4. In the Device IP field, enter the IP Address for the RVON-1 card.

5. From the Device Type drop down list, select RVON-1/Keypanel.

6. From the Device Channel drop down list, select Channel 1.

There may be two channels listed, but the connection can only be made through channel 1.

7. From the CODEC Type drop down list, select the CODEC type.

8. From the Packet Sized drop down list, select the size of each audio packet.

NOTE: A CODEC is an algorithm used to compress audio. Codecs dictate the quality of audio you hear

and the network bandwidth used. The packet size determines how much audio data is carried across

the network in each transmitted packet. The CODEC type and packet size chosen require different

amounts of bandwidth from the network. As with the CODEC type, the packet size you choose for

the audio transfer will affect the audio you hear and the bandwidth you use over the network. The

larger the audio packet you choose to use, the lower the bandwidth used. However, the larger

packet size can result in a higher delay and longer gaps if the packet is lost. On the other hand,

smaller packet sizes result in larger bandwidth use, but lower delays and smaller gaps if the packet

is lost. The Intercom System Engineer and the Network Designer may want to work together in

choosing the CODEC type and packet size suitable for the size of the network, so degradation of

network resources does not occur.

9. Select Enable VAD (Voice Activation Detection), if you want to conserve bandwidth when the audio level is below

a given threshold.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 103 104

Keine Kommentare

RTS Cstrunk Spezifikationen Seite 85