RTS Cstrunk Spezifikationen PDF herunterladen (Seite 101)

To edit the RVON-1 configuration, do the following:

1. Repeat steps 1 through 9 from above.

2. At the MXP prompt, type either set RVON or set EMAC (see screen descriptions below).

3. Press Enter.

NOTE: This Telnet screen is almost duplicate to the right side of the Configuration screen for the RVON in AZedit.

set rvon ip_addr Allows you to edit the IP Address

set rvon netmask Allows you to edit the netmask

set rvon gateway Allows you to edit the gateway

set rvon serial_ip Allows you to edit the serial IP Address

set rvon serial_baud Allows you to set the baud rate (50-38400)

set rvon user

Allows you to set the username for the RVON-1 card. By default

the user name is “telex”

set rvon password

Allows you to set the password for the RVON-1 card. By default,

the password is “password”

set rvon vad_threshold

Lets you set the vad threshold.

NOTE: In AZedit, you can enable and disable VAD,

however, through Telnet you able to set the amount.

You will able to set the VAD threshold in later

versions of AZedit.

1 2 ... 96 97 98 99 100 101 102 103 104

Keine Kommentare

RTS Cstrunk Spezifikationen Seite 101