RTS XCP-24 Wartungshandbuch PDF herunterladen (Seite 54)

6-16 KP-632 User Manual

Service Menu, Mic Select

This menu item allows the user to select between the Panel and Headset Mic. In the Normal

(defualt) setting, audio from the Panel Mic used. In the Hdst Only, setting audio from the Headset

Mic is used.This is used to force the use of the headset microphone even when the keypanel’s

speaker is being used.

1 Select

Mic Select

from the Service menu, then tap PGM.

2 →

Normal

displays

3 Press ↓↓ to select either

Normal

Hdst Only

4 Tap PGM

5 Tap CLR to exit

6 Run Service Menu, Save Cfg, to store Mic Select settings.

Service Menu, Min Volume

This menu item allows the user to set the minimum volume level for both the keypanel speaker

and the headset speaker(s). This is the minimum volume level available on the volume control

located on the front panel of the KP-632.

1 Select

Min Volume

from the Service menu, then tap PGM.

2 →

Speaker

displays

3 Press ↓↓ to select either

Speaker

Headset

4 Tap PGM

5 Press ↓↓ or −− to increase or decrease the minimum volume level. The range is -24 dB to

-60 dB or full Mute.

6 Tap PGM

7 Tap CLR to exit

8 Run Service Menu, Save Cfg, to store Min Volume settings.

Service Menu, Mod Assign

Note

Normally, this is a service adjustment that is required only when replacing a key and display

module. It may also be required if for some reason, the key assignments, as displayed in

ADAMedit, appear to be in the wrong positions on the keypanel or expansion panel.

The KP-632 and EKP-632 use module ID numbers (Mod ID numbers) to define the address of

each key and display module. See Figure 6.2. By default, Mod 1 is always assigned to the right

half of the KP-632 and this never changes, since this module has the keypad and is unique.

However, the rest of the modules are identical. When replacing any of these modules, you may

have to reset the Mod ID number as follows:

1 Select

Mod Assign

from the Service menu and tap PGM.

Cancel?

displays. To exit the procedure without making changes, tap PGM.

3 All of the alphanumeric displays, except Mod 1, will appear as shown in Figure 6.2. Assign the

Mod IDs as shown in the figure. Repeat the procedure for each module.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 113 114

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS XCP-24 Wartungshandbuch Seite 54

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Türsprechanlagen RTS XCP-24