
6-12 KP-632 User Manual
2 Tap PGM.
3
Meter: Mic
displays. Press ↓↓ or −− .to display any of the following items:
Meter: Mic
Meter: Mtx
Meter: Aux1
Meter Aux 2
4 Tap PGM.
5 The Vol. bar graph is now monitoring the selected audio source.
6 Tap CLR to exit metering, or allow the metering function to timeout after about 1 minute.
Mixing
Mixing lets you route selected audio signals to the intercom system, to the speaker, or to the left
or right headphone when using a headset. By default, the microphone signal is routed to the
matrix, and the matrix signal is routed to the speaker and to the left and right headphones.
1 Tap PGM.
2
To Matrix
displays. Press ↓↓ or −− .to display any of the following items:
To Matrix
Speaker
Left Hdst
Right Hdst
3 Tap PGM.
4 →
Mic
or
Mic
displays. If an arrow displays, this indicates that the mic signal is currently being
routed to the destination that you selected in step 2. To toggle the selection, press PGM. You
can also press ↓↓ or −− .to display and toggle any of the following items:
Mic
Matrix
Aux 1
Aux 2
5 Tap CLR to exit when you are finished changing the mixing selections.
6 Run Service Menu, Save Cfg, to store any mixing changes.
Service Menu, Hdst Sel
This item lets you select either the front panel headset jack or the headset connector on the
optional rear connector module. By default, the front panel jack is selected.
1. Select
Hdst Sel,
then tap PGM.
2. →
Default
displays. The arrow indicates the default front panel jack is selected.
3. To change the selection, press ↓↓ .
4.
External
displays.
5. Tap PGM.
6. →
External
displays. This indicates that the rear panel jack is now selected.
7. Tap CLR to exit.
8. Run Service Menu, Save Cfg, to store the new setting.
Kommentare zu diesen Handbüchern