RTS RVON-I/O Bedienungsanleitung PDF herunterladen (Seite 23)

CHAPTER 3

Configuration

Setup IP Addresses

There are three ways in which the IP Address can be set on the RVON-I/O; via a keypanel, through Telnet, or using the Serial

Debug Port.

If you are using a keypanel to set the IP Address of the RVON-I/O, you must use a KP-32, KP-632, KP-832, or a KP-812.

There are two sets of instructions to configure the IP Address from a KP-32, KP-632, KP-832 and a KP-812. This is because

the KP-812 uses encoder knobs to navigate its menu system. For instructions on how to use the KP-812 to configure the IP

Address, see “Configure the IP Address from a KP-812” on page 18.

Configure the IP Address from a KP-32, KP-632, or a KP-832

NOTE: Make sure DIP switch 1 is in the OPEN position (LOCAL mode - LED 24 RED is NOT lit). Also, make sure DIP

switch 2 is in the CLOSED position (configuration via IO port 8 enabled).

To configure the IP Address from a KP-32, KP-632, KP-832 keypanel, do the following:

1. Connect the RVON-I/O using serial cable from the IO port 8 on the unit to the FRAME connector on the KP-32, KP-

632, or KP-832.

NOTE: The firmware on the KP-32, KP-632, KP-832 keypanels needs to be at version 2.0.2 or higher.

2. On the KP-32, KP-632, and KP-832, press Menu.

The Display menu item appears.

3. Press the up arrows or down arrows to scroll to Service.

4. Press PGM.

The Aux Inputs menu item appears.

5. Press the up arrows or down arrows to scroll to RVON Setup.

6. Press PGM.

The IP Address menu item appears.

7. Press PGM.

The current IP Address appears.

8. Enter the first number in the IP Address.

This activates the first octet of the IP Address and clears the rest of the IP Address.

9. Press PGM.

This confirms the first octet in the IP Address and moves you to the second octet.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Keine Kommentare

RTS RVON-I/O Bedienungsanleitung Seite 23