RTS RVON-I/O Bedienungsanleitung PDF herunterladen (Seite 16)

4. Connect the RVON-I/O to Ethernet.

5. Set the IP Address for the RVON-I/O (see “Setup IP Addresses” on page 17).

6. Using Telnet or Serial programming, configure the RVON-I/O as follows:

set channel [chan]

dest ip_addr (IP Address of the RVON-1, RVON-8, or RVON-I/O that is connected to the RVON-I/

dest_type (the type of device, either an RVON-1, RVON-8, or RVON-I/O)

dest_chan

dest_codec

set panel [panel]

poll_id (see “Set Panel” on page 32)

NOTE: If the RVON-I/O is in Remote Mode, set the Panel Poll ID to 0, so it will not be seen as

keypanel.

baud

NOTE: To see actual Telnet commands, see “RVON-I/O Command Table” on page 25.

7. Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the

configuration setup on the RVON-I/O

8. To set up the other side of the trunk system, repeat steps 1 through 7.

RVON Serial Pass-through Setup

The Serial Pass through is the path in which data is sent and received.

1. Verify the correct port is selected - on J1 see “Pin Outs for Connections” on page 4.

2. Verify the serial connections are correct.

3. Verify Pass Through Port is enabled (DIP Switch 2 OPEN), see “Connection Diagrams” on page 5.

4. Verify the RVON-I/O baud rate matches the baud rate of the device it is connecting with.

5. Using Telnet or Serial programming, configure the RVON-I/O as follows:

set serial

mode

ip_addr

baud

NOTE: To see actual Telnet commands, see “RVON-I/O Command Table” on page 25.

6. Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the

configuration setup on the RVON-I/O.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Keine Kommentare

RTS RVON-I/O Bedienungsanleitung Seite 16