RTS RVON-I/O Bedienungsanleitung PDF herunterladen (Seite 14)

Reset the Current IP Address to the Default RVON-I/O IP Address

The RVON-I/O is shipped with a default IP Address already configured on the unit. The default IP Address is 192.168.0.1,

the default Netmask is 255.255.0.0, the default Gateway is set to zero. This feature is useful when using an RVON-I/O in the

field (i.e.; a mobile truck) where the IP Address is constantly changing from on destination network to the next. By being able

to reset the IP Address to a default address, you will be able to connect to the RVON-I/O without having to remember the IP

Address of the previous location. For more information on configuring the IP Address, see “Reset the Current IP Address to

the Default RVON-I/O IP Address” on page 8.

To reset the IP Address to default on the RVON-I/O, do the following:

1. On the front of the RVON-I/O unit, push and hold buttons 1 and 2, then push the RESET button.

Hold the buttons in for 15 seconds or until all the LED lights blink rapidly. When all the LED lights blink rapidly, the

RVON-I/O IP Address has been reset to the default.

NOTE: If buttons 1 and 2 are pressed during power ON, the unit will reset the IP Address.

Basic Installations

On the following pages, installation for Basic Local Mode, Basic Remote Mode, and Basic Trunked systems will be explained.

NOTE: When using Zeus with RVON-I/O GPI/O you must uncheck the “Configure onboard GPI/Os in FR9528 mode”

BEFORE you configure your system. If you set this after you configure your panels, it will cause the Zeus

configuration to be reset.

Basic Local Mode Setup

NOTE: Keypanel version is not relevant in Local Mode.

In LOCAL mode, the keypanel is directly connected to the RVON-I/O through the use of a DB-9 serial cable.

To setup an RVON-IO local mode system, do the following

1. On the back of the RVON-I/O, put DIP switch 1 in the OPEN position (LOCAL mode).

2. Power ON the RVON-I/O unit.

3. Connect keypanels to the RVON-I/O (I/O ports), using a straight DB-9 (serial cable). See page 5

4. Connect the RVON-I/O to the Ethernet.

5. Set the IP Address for the RVON-I/O.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Keine Kommentare

RTS RVON-I/O Bedienungsanleitung Seite 14