RTS XCP-48-RJ45 Bedienungsanleitung PDF herunterladen (Seite 85)

Configure the Devices Connected to the RVON-C Card

See the device user manual for specific configuration instructions

Setting up a Serial Pass-Through Connection or Serial Connection

If you plan to pass data using either a Serial Pass-Through or Serial Connection you will need to set the DIP switches and

jumpers to reflect which connection you will want to use.

NOTE: When making adjustments to the DIP switches and jumpers, you will need to take the front card out of the

Cronus.

To use the Serial Pass-Through, do the following:

1. Set DIP Switch 6 to the OPEN position.

2. Set the serial protocol, either RS232 or RS485:

• For RS232, jumper pins 2 & 3 of J10, J11, and J12

• For RS485, jumper pins 1 & 2 of J10, J11, and J12

3. Once you have set the correct configurations, replace the RVON-C into Cronus and hook the DB-9 connector to the

RVON-C backcard.

To use the Serial connection, do the following:

1. Set DIP Switch 6 to the CLOSED position.

2. Set the serial protocol, either RS232 or RS485:

• For RS232, jumper pins 2 & 3 of J10, J11, and J12

• For RS485, jumper pins 1 & 2 of J10, J11, and J12

3. Once you have set the correct configuration, replace the RVON-C into Cronus and hook the DB-9 connector to the

RVON-C backcard.

4. Use Table 4, “Serial Command Table,” on page 73 to configure you RVON-C card.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 106 107

Keine Kommentare

RTS XCP-48-RJ45 Bedienungsanleitung Seite 85