RTS XCP-48-RJ45 Bedienungsanleitung PDF herunterladen (Seite 59)

TABLE 2. RVON-C Status Descriptions

ACTION DISPLAY

When Ethernet is selected:

Link Up - Displays whether the Ethernet link is active or inactive.

Link Up=Active, Link Down=Inactive

Speed - Displays the connection speed in mbps. Can be either 10mbps or 100mbps.

Mode - Displays whether the connection is Half Duplex (data that moves in one

direction) or Full Duplex (data that moves in both directions).

Auto-Negotiate - Automatically determines the Ethernet speed and mode, and then

adjusts the settings accordingly.

When Serial is selected:

IP - Displays the IP Address of where the transfer is being sent.

Baud - Displays the connection speed of the RVON-C.

To Net - Displays the number of bytes that have been transferred from the serial port.

To Ser - Displays the number of bytes that have been transferred to the serial port.

When VoIP Channel is selected:

VoIP........ - displays the channel connection status to other RVON devices. The

channel connection shows connections to RVON-8, RVON-I/O,

RVON-1, RVON-C, and VKP.

Each dot (or checkmark) represents a channel connection. There are

eight channel connections for each RVON-C card.

If a dot (•) is seen in the display, this means that the channel is not

connected to a RVON device.

If a checkmark () is seen in the display, this means that the channel

is connected to an RVON device.

Panels......... - displays whether or not there is a keypanel connected at the other

end of the channel connections.

Each dot (or checkmark) represents a channel connection. There are

eight channel connections for each RVON-C card.

If a dot (•) is seen in the display, this means that the channel is not

connected to a keypanel.

If a checkmark () is seen in the display, this means that the channel

is connected to a keypanel.

NOTE: Channels are ordered from left to right.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 106 107

Keine Kommentare

RTS XCP-48-RJ45 Bedienungsanleitung Seite 59