RTS XCP-40-RJ11 Installationsanleitung PDF herunterladen (Seite 24)

Device Connections

The intercom port addresses for program input, as well as the low and high ranges for IFB output, are stored in EPROM

memory in the PAP. In some cases, it may be desirable to control program sources and IFB ranges other than those allowed by

the defaults. In such cases, new custom EPROMs can be programmed as needed. Contact your intercom system dealer for

further information.

Connecting a Single PAP

Connect a single PAP to J3 of the Master Controller Breakout Panel as shown in ADAM-101 through ADAM-108

interconnect diagrams on starting on page 35. Use and RS-485 data cable wired as shown in the ADAM-809 installation

drawing on page 53. Connect power to the AC mains connector.

Connecting Additional PAPs

Connect any additional PAPs by wiring them in parallel with the first PAP.

Change the panel number DIP switches in all but one of the PAPs. To do this, remove the covers from the PAP and locate the

8-position DIP switch block on the PMC-15 circuit board. By default, all PAPs are supplied with DIP switches #1 and #2 set

for panel number 1. Reset the switches as shown in Table 6 on page 15, so that each PAP has a unique panel number.

By default, all PAP systems are supplied with the lower of two ranges of IFBs selected. For example, a PAP-952 is set by

default to work with IFB numbers 1 to 24. If a second PAP-952 is connected, it can be reset to work with IFB numbers 25 to

48, if desired.

NOTE: DIP switches 4-8 in PAP systems are not used and their position does not matter.

Programming IFB Defaults to Initialize PAPs

Before a PAP can reassign program inputs, a default configuration for each IFB must first be setup using AZedit. See

“Creating an IFB”.

Note, it is not necessary to have any program sources or output stations connected to setup the IFBs.

Checking PAP Operation

Status of a PAP can be checked by selecting PAP from the Status menu in AZedit.

Alternatively, it is possible to check PAP operation using the XPT (Crosspoint Table) in AZedit. When you select “Force and

Inhibit” from the System menu in AZedit, a port pick list appears. Select one of the IFB output ports. A “Connecting Ports”

table for that port appears. As program sources are reassigned on the PAP front panel, the changes can be viewed in the table

by pressing the ENTER key. As each new program source is connected, a check mark appears next to that port in the table.

TABLE 11. PAP Addresses

Model

Default Ports for

Program Input

Panel No.

(Default = 1)

IFB Range

Low (Default) High

PAP-940 1-24 1-4 1-40 41-80

PAP-950-50 1-50 1-4 1-50 51-100

PAP-951 1-8 1-4 1-12 13-24

PAP-952 1-16 1-4 1-24 25-48

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

Keine Kommentare

RTS XCP-40-RJ11 Installationsanleitung Seite 24