RTS XCP-40-RJ11 Installationsanleitung PDF herunterladen (Seite 13)

CDP-950 Camera Delegate Panel Installation Notes

Installing the CDP-950

1. Before installing the CDP-950, remove the top cover and set the internal DIP Switches:

2. Connect the CDP-950 to the data for any one of the intercom ports that will be controlled. Several possible cable wiring

diagrams are shown in Figure 22 on page 54

3. Connect beltpacks, camera intercoms, etc. to the audio input and output pins or each intercom port controlled by the

CDP-950.

Programming the CDP-950

Run AZedit and assign the CDP-950 keys just as you would normal keypanel keys. For each intercom port, the PL1 through

PL4 keys on the CDP-950 correspond to keys 1 through 4 in the AZedit key assignment table.

NOTE: When a key is activated, both the talk and listen assignment for that key will activate.

DIP #1 Normal/ISO Select

Closed: Normal Operation

Open: ISO Operation

DIP #2 Baud Rate Select

Closed: 9600 baud

Open: 76,800 baud (Do not use for ADAM)

DIP #3 Not Used (position does not matter)

DIP #4 - #8 Intercom range select (see Table 4 on page 14 for settings.)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Keine Kommentare

RTS XCP-40-RJ11 Installationsanleitung Seite 13