RTS TR-240 Spezifikationen PDF herunterladen (Seite 25)

BTR-240 Operation

This section discusses the operation and features of the BTR-240

base station. This section outlines the basic operation, hardware

interfaces, and setup of the base station.

Basic Operation Description

The BTR-240 digital wireless intercom system offers one of the

most comprehensive, user friendly and versatile set of features

available in wireless intercom systems anywhere in the world.

The base station comes with the ClearScan intelligence which

automatically selects the optimal RF channel for communication.

The BTR-240 base station can accommodate up to 8 full-duplex

wireless TR-240 beltpacks. The base station may also be used

with an unlimited number of beltpacks in half-duplex operation.

The base station, via the local headset or the associated beltpacks,

allows communication with other wireless or wired users. The

2-wire and 4-wire intercoms may even be used simultaneously.

The wired audio interfaces to the base station are:

•

2-Wire (RTS, Audiocom (Telex), Clear-Com) – 2 intercom

channels

•

4-Wire – 2 intercom channels

•

Auxiliary (input and output)

•

Speaker (output)

•

Local base station headset

Powering the Base Station

The BTR-240 base station is powered from an external 12 – 15

VDC supply. The base station accepts a 5.5 mm by 2.5 mm screw

on plug. The source must supply at least 1.5 Amps.

Power the base station via the front panel switch labeled “Power”

by moving the switch to the on, “ | ”, position. Turn off the base

station by moving the switch to the off, “ O ”, position.

NOTE: The supplied power source has been approved for use

with the BTR-240. Users should only use the supplied

power source when operating the BTR-240. For

replacement power supplies, see the “Accessories and

Replacement Parts” section for ordering information.

Boot Screen

Once the power switch on the BTR-240 has been turned on, the

buttons and LCD backlights will illuminate. The base station

takes approximately 25 seconds to complete its boot cycle. While

the base station is booting, the status is indicated by a progress bar

on the LCD.

Start-up Screen

Once the base station has finished booting and the progress bar

has been filled completely, the Start-up Screen will be displayed

for approximately 3 seconds. While this screen is displayed, it

will blink the software version numbers of the base station. The

first one will be shown in the lower left corner and the second in

the lower right corner of the LCD.

NOTE: A complete screen flowchart of the base station is

available in Figure 5-47 at the end of this section.

5-1

Section 5 - BTR-240 Operation

Bosch Communications

BTR-240

A(1.0.0) 4.0

Figure 5-2

Start-up Screen

Bosch Communications

BTR-240

Bosch Communications

BTR-240

Figure 5-1

Boot Progress Screen

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS TR-240 Spezifikationen Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Türsprechanlagen RTS TR-240