RTS TR-240 Spezifikationen PDF herunterladen (Seite 23)

System Quick Start Guide

The following is a list to quickly get the BTR-240 base station and

wireless TR-240 beltpacks operating.

1. Select a location for the BTR-240 base station and connect

the power cord and antennas.

•

When using omni-directional antennas, place the base

station as close to the center of the coverage area as

possible.

2. Connect any desirable external audio interfaces. For

example: 2-Wire, 4-Wire, Auxiliary, Speaker, local headset.

3. Turn on the base station.

•

The menu buttons and LCD backlight illuminate and a

progress bar displays the status while the unit is booting.

•

After approximately 25 seconds, the base station will

have completed the boot cycle and the Status Screen will

be displayed.

•

Activate the connected audio interfaces by navigating

the menu on the LCD screen.

4. Perform a ClearScan.

•

After the base station has completely booted, press and

hold the <MENU> + <SET> buttons for approximately 3

seconds.

•

The base station will run the CleaerScan operation and

select the optimal RF channel for operation.

5. Plug headsets into the TR-240 beltpacks and turn them on,

one by one.

•

If the beltpack has not been previously set to wireless

mode, press and hold the button while the beltpack

boots.

•

Allow a few seconds between each beltpack power on.

•

After approximately 20 seconds, a voice prompt will

announce “wireless” in the beltpack headphones

indicating that wireless communications has started.

•

The base station will increment the association status on

the Status Screen next to “Assoc: XX” for each of the

active full-duplex beltpacks.

The BTR-240 wireless intercom system is now ready for

operation!

TALK

CHANNEL

SELECT

VOLUME

BTR-240

POWER

set

Figure 4-9

BTR-240 Supporting 8 Wireless TR-240s

4-5

NOTE: Additional setup information can be found in the "Operating for

the First Time" section of the operating manual.

NOTE: Prir to use, the TR-240s should have their battery packs fully

charged. Refer to the “Battery Charging Instructions” in this

section.

NOTE: While booting, avoid pressing the beltpack buttons so the mode

of operation is not changed unintentionally.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS TR-240 Spezifikationen Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Türsprechanlagen RTS TR-240