RTS TM-2000 Bedienungsanleitung PDF herunterladen (Seite 35)

Addendum 2

Zeus DIP Switches

Document: Zeus Getting Started Manual, Rev A

Addendum Number: 2

General Instructions: Use this addendum with Revision A of the manual. This information will be

included in Revision B.

Subject: There are several internal DIP switches which modify the operation of the Zeus Frame. Switch

descriptions and default settings are summarized below. To access the DIP switches, unplug the power

cord, then remove the case cover.

Switch Number Description Default

Setting

1 Baud rate select

Off: 9600 baud

On: 38.4 Kbaud

Off

2 Keypanel Incoming message option

Off: Normal operation

On: All callers display in Incoming Messages window

Off

3 Keypanel "in-use" and "busy" flash

Off: Enable

On: Disable

Off

4 Not used (set to off) Off

5 Not used (set to off) Off

6 Not used (set to off) Off

7 Not used (set to on) On

8 Test on/off

Off: Normal operation

On: Test mode

Off

DIP Switch Notes

Make sure that the rate set here matches the rate set in Zeus-edit. 9600 baud permits a longer PC cable, but uploads and

downloads will be slower (approximately 30 seconds for a complete system update). Alternatively, 38.4 kbaud will

provide faster uploads and downloads, but the PC cable should be kept to a length less than 10 ft (3m), and some older

PC's may not operate reliably at this speed.

Normally, when a call is received by a keypanel, the keypanel checks for a talk key assigned to the caller. If there is an

assigned talk key, the display for that key will flash, and the keypanel operator may then press that key to talk back. If

no key is assigned, the caller's name will appear in the incoming messages window (also called call waiting window),

and the keypanel operator may press the incoming messages key to talk back. Some intercom systems may have many

WARNING

The following instructions are for use by qualified personnel only. To avoid electric shock, do not remove

the cover unless you are qualified to do so.

AVERTISSEMENT

Les instructions qui suivent s'adressent uniquement a un technicien qualifie. Pour evite des chocs

electriques, ne pas ouvrir le boitier, a moins d'y entre habilite.

1 2 ... 30 31 32 33 34 35 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare

RTS TM-2000 Bedienungsanleitung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Türsprechanlagen RTS TM-2000