RTS XCP-ADAM-MC Bedienungsanleitung PDF herunterladen (Seite 42)

Default Setup

Every attempt is made to ensure the board is shipped from the factory containing the following:

All are “set rvon” commands

Variable Environment Name Default Value Description

ip_addr EMACA_IPADDR 192.168.1.1 IP address for the RVON-8 Card

netmask EMACA_NETMASK 255.255.255.0 Network mask for the RVON-8 Card

gateway EMACA_GW none Gateway IP address for the RVON-8 Card

serial_ip RVON_SERIAL_IP none Pass-thru serial port IP address for the RVON-8

Card

serial_baud RVON_SERIAL_BAUD 9600 Set the pass-thru serial port baud rate for the

RVON-8 Card

user RVON_USER telex RVON-8 user name for telnet access

password RVON_PASSWORD password RVON-8 password for telnet access (8-40

characters)

vad_threshold RVON_THRESHOLD_VAD adaptive VAD Threshold

There are more parameters that the software will auto-configure if they have not been previously

setup. The user can also set these parameters, in which case the software would not modify but

take them as they are.

All are “set chan #” commands because they are for each audio channel.

Variable Environment Name Value Description

dest_ip RVON_DEST_IP_# X.X.X.X Destination IP Address for this particular RVON_CH

dest_type RVON_DEST_TYPE_# X Destination Type Y = 0(rvon-8) 1(rvon-1) 2(rvon-10)

dest_chan RVON_DEST_CHAN_# X Destination Channel – what port of far-end (0-7)

chan_codec RVON_CHAN_CODEC_# X Profile to use (previous coding table)

Typing, "printenv, then pressing Return" from RVON-8 boot code or "sys_printenv" from the

"MXP)" Debug System Prompt may show these commands. The Environment Name is listed

because this is the label used by the software.

IMPORTANT!: If the user is attempting to do a “setenv” to change a parameter from the RVON-8

boot code, the Environment Name must be used and NOT the “set rvon variable” name.

1 2 ... 37 38 39 40 41 42

Keine Kommentare

RTS XCP-ADAM-MC Bedienungsanleitung Seite 42