
18 Installation TM-2000 & MTM-2000 User Manual
Bosch Security Systems, Inc.
User Manual
F.01U.193.264
Rev. 12
To install TM-2000 Trunk Master software, do the following:
1. Reboot the TM-2000 with the Trunk Master Software CD in the CD-ROM drive.
The TM-2000 Trunk Master Software prompt screen appears.
2. In the Option field, enter 2.
3. Press Enter () to confirm your selection.
A warning message appears.
4. Press Enter () to confirm your selection.
The configuration window appears.
5. From the Please select one of the following configurations window you can:
• select 1 if using only one (1) trunk master.
• select 2 if trunk master is the active unit of a redundant system.
• select 3 if trunk master is the standby unit of a redundant system.
6. Press Enter () to confirm your selection.
The This computer: setup information window appears.
7. In the Do you want to change any of these values (y/n) field, enter n (use lowercase).
8. Press Enter () to confirm your selection.
The Enable VDP support (y/n) window appears.
9. In the Enable VDP support? (y/n) field, enter n or y (use lowercase).
• Choose yes if there is a VDP-2000 in the system.
• Choose no for systems without VDP-2000 units.
TM-2000 Trunk Master Software
Options:
1. Run a demo version of the TM-2000 off the CD.
2. Install the TM-2000 software on the hard drive.
3. List PCI devices and check for interrupt conflicts.
Option?
You will have several chances to quit without losing any information. (More...)
Please select one of the following configurations:
1. Stand-alone operations.
2. Active/standby, active by default.
3. Active/standby, standby by default.
Configuration?
This computer:
Mode: Stand-alone
Host name: tm_solo
IP Address: 10.201.202.203
Workgroup/Domain: WORKGROUP
Do you want to change any of these values? (y/n)
Enable VDP support? (y/n)
Kommentare zu diesen Handbüchern